Vision VR48 4 Series User Manual page 328

328 Vision VR48 Series 4 Router User Manual
Then placing a check mark in the Selected option box near the bottom center of this window. Click on
Apply, then Close to save this change.
After selecting the Engrave icon from the left toolbar, the cut preview window is shown. Two important
things to remember are: 1 - make sure only the text is showing in this window, and 2 - look at the bottom
right corner of this screen to make sure that only one page is available (the page selection box should
only show 1/1 if you are sending over only Selected objects). If your setup is correct, proceed with
sending the job to the engraver.
© 2015 Vision Engraving and Routing Systems