Table of Contents
Advertisement
Example Jobs
151
NOTE - The design of the Vacuum Chip Removal System is to clear the debris away from the engraved
material and prevent the chips from scratching the surface of the material during operation, and/or
getting trapped between the nose cone and the material (when using the proximity sensor function) and
causing the engraver to not engrave to the proper depth.
When the file is complete, remove the material from the table. HINT - Use a light bristle brush to clean
out any debris that may remain in the engraved characters.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
