Table of Contents
Advertisement
Operation
105
Install the dust collector nozzle mounting shafts into the thumbscrew mounts and tighten the
thumbscrews. Install the support plate on to the top of the router head cover and secure with two
thumbscrews in the holes towards the front of the router head cover. Lay the dust collector hose on top
of the support plate and secure the hose using the hose brackets. Use thumbscrews to secure the rear
bracket to the support plate and screws/nuts to secure the front bracket. Slide the dust collector hose on
to the nozzle as shown.
NOTE - Make sure there is enough hose between the front bracket and the dust collector nozzle to allow
the router head to drop to its lowest position.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
