Table of Contents
Advertisement
The DACS Camera System
115
Highlight the STC camera by clicking on the icon under the Available GigE Vision Devices list. If
selected, it will highlight in blue as shown. Then, select Set IP Address... at the bottom of this screen.
Type in the IP address as shown below and select OK. (Make sure you are using a STATIC IP Address
and the recommended IP Address settings for your computer and the machine's controller).
Select OK when finished with this window, the Device window and the XMI Setting window.
You may be prompted to restart the DACS (VisionTool4) software. Click on OK and close/re-open the
DACS software.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
