Table of Contents
Advertisement
Once the DACS software has opened, click on the Live Camera Feed icon.
You may wish to jog the motion system over one of the Fiducial Markers to make sure it shows up
correctly as shown below.
Before sending the job to the machine, a good practice is to check that 4 procedures have been
performed.
1. Material Set. The material is positioned at the top left corner of the table.
2. Tool Set. The proper cutting tool has been installed.
3. Surface Set. The Set Surface procedure has been performed (if the Proximity Sensor is not being
used).
4. Home Set. The machine's home has been set to the material's upper left corner (the machine's home
position, if the material is positioned as suggested here).
© 2015 Vision Engraving and Routing Systems
The DACS Camera System
133
Advertisement
Table of Contents
