Vision VR48 4 Series User Manual page 18

18 Vision VR48 Series 4 Router User Manual
On the front of the control box for VR48 Router, there are four connection ports; One is an Ethernet
port used to connect your computer or network to the on-board Series 4 Controller, the second is for
the Pendant, the third is another Ethernet port used to connect a computer to the optional DACS
Camera System, and the fourth is to connect the Remote Start Switch for the Dust Collector System.
Plug the network cable (or the crossover cable) into the BOTTOM Ethernet port on the VR48, then either
plug the network cable into your network (or hub), or using the crossover cable, plug into the network
port on your computer. Plug the Pendant cable into the Pendant and Pendant Port on the VR48.
Connections for the DACS Camera System are detailed in a separate section of this manual. Connect
the Dust Collector Remote Start Cable to the Remote Start Port using the supplied cable.
NOTE: The crossover cable is colored gray.
© 2015 Vision Engraving and Routing Systems