Vision VR48 4 Series User Manual page 278

278 Vision VR48 Series 4 Router User Manual
Select the Engrave icon from the left toolbar, set the Device to your machine, select Engraver's Plastic
(Engraving) from the Tool Setup window, and click on the Engrave icon in the Cut Toolbox. Note that the
material used here (yellow) is placed on top of MDF, which is used as both a spoil board and a vacuum
surface. Any exposed areas of the MDF were covered to maximize vacuum.
Only the black items should show in the Vision 9 software prior to sending the engraving portion to the
machine. The below picture is after the engraving has finished.
© 2015 Vision Engraving and Routing Systems