Vision VR48 4 Series User Manual page 80

80 Vision VR48 Series 4 Router User Manual
, then
then press the Spindle On/Off button, the spindle motor will start. Pressing Shift, then the Spindle On/Off
button again will shut the spindle motor off. The Pendant screen will display On (Auto) when the spindle
is turned on.
Aux On/Off Button - The auxiliary for an optional vacuum system motor can be either in
automatic mode or off. You can toggle between these two modes by pressing the Aux On/Off button.
The Pendant screen with display either Vac: Off (Auto), or Vac: Off. When set to Auto, it will
automatically turn on and off at the beginning and end of the engraving job. If you press the PAUSE or
STOP button, the vacuum will turn off for safety reasons. Always make sure you have the vacuum
turned on when appropriate to remove chips that will be created during engraving.
Note: The auxiliary can be changed to on or off from within the Vision Pro software. When the Engrave
icon is selected, the auxiliary icon can be selected or deselected to automatically turn the vacuum on or
off when the job is running.
Auxiliary on icon:
Auxiliary off icon:
, then
then press the Aux On/Off button, the optional vacuum pump will start. Pressing the Aux On/Off button
again will shut the vacuum pump off.
Shift, then Spindle On/Off Button - When you press the Shift button.
Shift, then Aux On/Off Button - When you press the Shift button and
© 2015 Vision Engraving and Routing Systems