Vision VR48 4 Series User Manual page 122

122 Vision VR48 Series 4 Router User Manual
The Controller will calculate the camera scale and set it automatically. Press Enter on the Pendant to exit
this screen.
In order to set the Camera Offset, first install a cutter UPSIDE DOWN in the spindle so that the flat end
of the cutter extends below the nose cone. Jog the motion system over the top of a fiducial marker,
lower the spindle until the cutter almost touches the material, then use the X and Y Arrow buttons to
center the cutter over the fiducial marker as shown.
Press Set Home, then Enter on the Pendant. Press Go to Home, then press Set Surface and then press
Enter. Press the Prox On/Off button and set the Prox to OFF. Press the Spindle On/Off button and set
the spindle to OFF. Go to the Menu on the Pendant, select DACS, then Set Camera Offset. The screen
should appear as below. Press Enter to mark the current Home Position as where the fiducial marker is
located (this is why the Home was set over the fiducial marker in the prior step).
Press the Go to Home button and remove the cutter.
© 2015 Vision Engraving and Routing Systems