Vision VR48 4 Series User Manual page 130

130 Vision VR48 Series 4 Router User Manual
Now that the Fiducials have been set to Pen 99, select only 3 of the Fiducials that you want to have the
Camera System use for positioning. It is good practice to look at the Fiducials that are printed on your
material and choose 3 of them that have been printed clearly and form a right angle. In the below
picture, the top right Fiducial was deleted from the drawing and the remaining 3 Fiducials remained for
the DACS software to use.
Create a tool path for the items you want to cut. In this example, a male tool path was created around
the Vision logo. Note that in areas where there are internal corners, the tool path may allow for white
areas to be exposed after cutting. In order to correct this problem, either the print bleed needs to be
increased, the graphics need to be modified to widen the angle of these interior corners, the tool path
needs to be adjusted to have a negative Gap (which will cut into the graphics in all areas by the amount
of negative Gap), or a smaller diameter tool will need to be used.
© 2015 Vision Engraving and Routing Systems