Table of Contents
Advertisement
Example Jobs
203
Before sending the job to the machine, we need to place the material on the table, secure it with clamps
(or other hold down methods) and set the surface of the material.
Since we are not using the proximity sensor in this application and are setting the cut depth based on
the settings in the tool path we previously created, we need to use the Set Surface feature on the
machine. Before doing so, install the cutter so that the cutter tip extends MORE than the cut depth set in
the tool path. In this example, the cut depth was set to 0.150 inches. In the below picture, the cutter tip is
shown extending approximately 0.250 inches below the vacuum nose cone. This is critical when not
using the proximity sensor. If the tip does not extend more than the cut depth, the nose cone will stop the
tool from cutting to its proper depth.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
