Vision VR48 4 Series User Manual page 67

Router, Engraving and Knife Heads 67
Setting Surface
When running jobs with the Oscillating Knife, the surface must be set on the machine to the top of either
the Cutting Pad (for machines with the Vacuum Table), or the MultiMat material (for machines with T-
Slot Tables). Below is the procedure to set the surface.
Turn on the machine's controller, home the machine and move the spindle over to a location near the
middle of the table. If using the Cutting Pad, TURN ON THE VACUUM PUMP. The vacuum pump must
be running to pull the Cutting Pad and MDF Board down against the vacuum table, otherwise the surface
set in this procedure will not be accurate and incomplete cutting will result.
Plug the Surface Sensing Block Connector into the Port on the left side of the Carriage and place the
Surface Block on the Cutting Pad under the Knife Blade as shown. The Spindle Clamp is NOT used
when setting surface with the Surface Sensing Block.
© 2015 Vision Engraving and Routing Systems