Carriage Ports Description - Vision VR48 4 Series User Manual

General Information - Installation 21
2.3

Carriage Ports Description

The connection ports on the right side of the carriage are shown below. Depending on the installed
equipment, these ports will be used to connect accessories or other accessories to the router.
DACS Ethernet Port - This port connects to the Ethernet cable plugged into the DACS Ethernet
Camera System*.
Proximity Sensor Port - This port connects to the proximity sensor cable when using the Engraving
Head*.
Spindle Port - This port connects to the spindle cable and provides power and control signals to the
High Frequency Router Head.
DACS Power Port - Connects to the DACS Power Cable plugged into the DACS Ethernet Camera
System*.
Misting System Port - This port connects to the Unist Misting System* and provides power to control
the system.
Oscillating Knife Port - Connects to the cable plugged into the Oscillating Knife*. This port provides
power and control signals to the knife.
Surface Sensing Block Port - Connects the Surface Sensing Block cable to the machines controller
when setting the surface of the material to be
processed.
*If equipped
© 2015 Vision Engraving and Routing Systems