Vision VR48 4 Series User Manual page 69

Router, Engraving and Knife Heads 69
WARNING: ONCE THE SET SURFACE KEY ON THE PENDANT IS PRESSED IN THE NEXT STEP,
THE KNIFE WILL BEGIN OSCILLATING. KEEP HANDS AND CLOTHING AWAY FROM THE KNIFE
OR SEVERE INJURY MAY RESULT.
Press the Set Surface Key on the Pendant. The knife will begin moving up and down (oscillating). Hold
the Surface Block down FIRMLY, then press and HOLD the Set Surface Key down. The spindle will
slowly start to move down toward the Surface Block. When the tip of the knife touches the Surface
Block, the spindle will move back up and the knife will stop oscillating. Release the Set Surface Key at
this time. The surface of the Cutting Pad (or MultiMat) is then stored in the machine's controller and the
Set Surface procedure is complete. Press Go To Home on the Pendant and unplug the Set Surface
Block Connector from the Carriage.
© 2015 Vision Engraving and Routing Systems