Vision VR48 4 Series User Manual page 220

220 Vision VR48 Series 4 Router User Manual
Since we have the Proximity sensor turned off, the machine will cut to a depth we set in out Tool Path
setup. It uses the surface position set with the Set Surface function as the "zero" depth and will lower
the cutter 0.875" below the material surface.
Caution: As with all applications, make sure you are ready to press the Emergency Stop or the
Pause button on the Pendant, in the event that the job was not set up properly and the cutter
moves too far down and starts cutting into the machine's table. Severe damage may occur if the
cutter is allowed to cut into the machine's table.
Once the job has been run, remove the material from the table. Note: In this example, the vacuum nose
cone was not used, but it is highly recommended to do so. As you can see by the waste remaining after
this piece was cut, there is a large amount of debris produced when cutting sign foam materials.
© 2015 Vision Engraving and Routing Systems