Table of Contents
Advertisement
General Information - Installation
17
2.2
Wiring Connections
The Main Power Switch is located on the left side of the VR48.
The main power supply is connected to the Main Electrical Box on the left side of the VR48. Remove
the cover and make the connections as shown below. Ground is connected to the bare wire and
common leads are connected to the two shielded wires. The supply for this connection is Junction Box
#1 (220 VAC, Single Phase).
Note: The picture below is for illustration purposes only. The power cable should enter the Main
Electrical Box through the hole in the left side of the box as shown in the above picture.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
