Vision VR48 4 Series User Manual page 71

Router, Engraving and Knife Heads 71
A new color swatch will be added to the swatch bar. Move the mouse over the new color and its Depth
Setting and Number of Passes will be shown. (One pass is sufficient for cutting most all substrates).
Select this color swatch by clicking once on it. All graphics drawn will use this color (and the Pen/Depth
settings assigned to that color).
After creating the cut file, select the Engrave icon from the left toolbar. Then set the Device as the
Oscillating Knife (large router) S4. If this Device is not listed, install this Device by closing the Cut
Toolbox and selecting File > Install > Cutting Devices, then selecting this Device from the list under
options for your Vision Routers (4'x8' and larger).
Select the Tool Setup icon (to the right of the Tool field on the top toolbar. The Tool Setup window for the
Oscillating Knife will appear. Choose either the Default setting, the Cardboard setting, or modify the
settings for Oscillation RPM and/or Cutting rate to optimize cutting the substrate being used. Select OK
when finished, then send the job to the machine by clicking on the engrave icon in the Cut Toolbox.
For further instructions on using the Oscillating Knife, please contact Vision technical support - 602-
439-0700.
© 2015 Vision Engraving and Routing Systems