Vision VR48 4 Series User Manual page 266

266 Vision VR48 Series 4 Router User Manual
Move the text below the circle as shown. Align the text so that it is Centered Vertically to the text on the
top of the circle, group the two lines of text, then center them both vertically and horizontally to the
circle.
At this point, we will need to write down the center position of the small circle on the bottom right of the
plate. Write down its coordinates; 11.125 X and 10.20 Y. We will need to reference this position when
positioning a dial which we will now create.
© 2015 Vision Engraving and Routing Systems