Vision VR48 4 Series User Manual page 126

126 Vision VR48 Series 4 Router User Manual
In the Vision software, select Engrave from the top menu bar, then click on Engraving Defaults.
Plot window will now be shown. Select the previously installed device in the Selected Device field, then
click on Setup. Note - if you have several machines, please contact Vision Technical Support to set up
individual folders for each device.
Select the Port tab, then select Direct to Port in the Method area - the Path shown should be c:\Vision
Machine Tools\Inbox. If this not the case, select Set Path and correct it. Set Port Location to File, then
click on Apply, then OK.
Click on Apply, then Close in the Plot window. Set up is now complete.
© 2015 Vision Engraving and Routing Systems