Table of Contents
Advertisement
Example Jobs
273
To set the number of passes used to cut through the material, select the
icon to the right of the
Depth field.
The Engrave Parameters window will appear. Click on the down arrow to the right of the Passes field to
set the number of passes to 1. Note that if you increase or decrease the number of passes, the Depth
per pass field and Last pass depth will automatically adjust to equal amounts. In most cases, when you
first open this window, these depth numbers will be incorrect, therefore, even if the number of passes is
correct, use the up and down arrows to change it, so that the other fields will auto correct themselves.
Click on OK to accept these settings, then click on OK to close the Female tool path window.
The plate should now show three different object colors (note the right side of the Vision 9 software
window - you can see which colors have been used in this job).
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
