Direct Connection To Computer - Vision VR48 4 Series User Manual

Series 4 Contoller and Vision 9 Software Installation 29
3.2

Direct Connection to Computer

Direct Connection to Computer Using Crossover Cable
Once the VR48 is connected directly to your computer's network port with the crossover cable (gray
colored cable), turn the machine on. Make sure all 4 emergency stops are not pressed. The main
power switch is located on the left side of the machine. The safety key switch for the VR48 is located
on the front left of the machine. Turn the main power switch to On, then turn the safety key switch to
On. Once the machine has initialized, plug the supplied Vision USB drive (or Orange USB Dongle) into
an available USB port on your computer.
NOTE - This installation is performed on a Windows 7 PC. For Windows XP, Windows 8, Windows 8.1
or Windows 10, the screens are slightly different.
The computer will recognize the USB drive
Select Open folder to view files.
and the following screen will appear.
Select Continue without scanning.
© 2015 Vision Engraving and Routing Systems