Table of Contents
Advertisement
The DACS Camera System
123
CAUTION - the spindle and motion system will run a short file after the Start button is pressed in the next
step. Keep hands or other items away from the machine!
Press the Start button on the Pendant.
CAUTION - The spindle should not turn on and it should not move down toward the material surface. If
this happens, press Pause and Cancel. Check to make sure the Spindle and Prox are turned off and
restart this procedure beginning with setting the camera scale.
After the file has run, use the X and Y Arrow buttons to jog the motion system so that the SAME fiducial
marker used can be seen in the center of the DACS software window. Try to get the marker as close to
the center of the window as possible.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
