Oscillating Knife - Vision VR48 4 Series User Manual

Router, Engraving and Knife Heads 65
4.4

Oscillating Knife

Mounting and Connecting the Oscillating Knife
Place the Oscillating Knife Assembly against the right side of the Rail Plate and align the mounting holes
with those in the Rail Plate. Install the 2 Mounting Screws and tighten the screws securely.
Plug the supplied cable (not shown) into the port on the top of the Oscillating Knife Assembly and plug
the other end of the cable into the Oscillating Knife Port on the Carriage.
NOTE: ALWAYS REMOVE THE OSCILLATING KNIFE FROM THE ROUTER WHEN USING THE
ROUTER OR ENGRAVING HEADS.
© 2015 Vision Engraving and Routing Systems