Vision VR48 4 Series User Manual page 268

268 Vision VR48 Series 4 Router User Manual
Set the Radius to 0.654 inches by entering this number in the Radius entry field. Press the Enter key on
the computer keyboard to set this radius.
Alternatively, you can click, hold and drag from the node near the top of the dial to adjust its radius,
although this is not an accurate way to size the dial.
Note - the dial you created will likely not display as shown below yet. To adjust the tick marks on the dial,
first, click on the Minor Tick settings icon on the top toolbar.
© 2015 Vision Engraving and Routing Systems