Snmp-Server Enable Port-Traps Atc Broadcast-Alarm-Clear; Snmp-Server Enable Port-Traps Atc Broadcast-Alarm-Fire - Edge-Core ECS4810-12M Layer 2 Management Manual

| Automatic Traffic Control Commands
C 32
HAPTER
snmp-server enable
port-traps atc
broadcast-alarm-
clear
snmp-server enable
port-traps atc
broadcast-alarm-fire
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast control-release interface
ethernet 1/1
Console#(config-if)
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no
form to disable this trap.
S
YNTAX
[no] snmp-server enable port-traps atc broadcast-alarm-clear
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-clear
Console(config-if)#
R C
ELATED OMMANDS
auto-traffic-control action (874)
auto-traffic-control alarm-clear-threshold (875)
This command sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control. Use the no form to disable this trap.
S
YNTAX
[no] snmp-server enable port-traps atc broadcast-alarm-fire
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-fire
Console(config-if)#
– 878 –