Lower Unit
10) Disassembly of Propeller Shaft Housing
1.
Tighten universal puller plate to make gap between reverse
gear (C gear) and propeller shaft housing.
Universal Puller Plate :
P/N. 3AC-99750-0
2.
Remove reverse gear (C gear) ass'y by putting two bladed
screw drivers into the gap to force the gap to open.
Use a press and suitable mandrel 1 to remove ball bearing.
3.
Before removing, check bearing for play or
deflection. Replace if necessary.
Do not reuse removed bearing.
Universal Puller Plate :
P/N. 3AC-99750-0
Use a press to remove oil seal 2 and needle bearing 3 at
4.
the same time.
Before removing, check bearing for play or
deflection. Replace if necessary. Direct
attachment with side without O-ring to needle
bearing.
Do not reuse removed bearing.
Needle Bearing Attachment 3 :
P/N. 3AC-99710-0
Driver Rod 4 :
P/N. 3AC-99702-0
6-12
CAUTION
CAUTION
1
4
3
2 Oil Seal
Do not reuse.
3 Needle Bearing
Do not reuse.
3
2
25/30 2006