Disassembly Of Propeller Shaft Housing - TOHATSU MFS 9.9 Owner's Manual

Lower Unit

10) Disassembly of Propeller Shaft Housing

1. Tighten universal puller plate to make gap between reverse
gear (C gear) and propeller shaft housing.
Universal Puller Plate :
P/N. 3AC-99750-0
2. Remove reverse gear (C gear) ass'y by putting two bladed
screw drivers into the gap to force the gap to open.
3. Use commercially available universal puller plate to remove
ball bearing.
Before removing, check bearing for play or
deflection. Replace if necessary.
Do not reuse removed bearing.
4. Use a press to remove oil seal 2 and needle bearing 3 at
the same time.
Before removing, check bearing for play or
deflection. Replace if necessary. Direct
attachment with side without O-ring to needle
bearing.
Do not reuse removed bearing.
Needle Bearing Attachment 3 :
P/N. 3BA-99710-0
Driver Rod 4 :
P/N. 3AC-99702-0
6-12
CAUTION
CAUTION
4
3
2 Oil seal
Do not reuse.
3 Needle bearing Do not reuse.
3
2
4st 9.9/15/20 2008