Disassembly Of Drive Shaft Housing - TOHATSU MFS 25D Service Manual

5) Disassembly of Drive Shaft Housing

Remove the upper rubber mount installation bolts 1 and
1.
remove the rubber mounts 2 and the dampers 3 from
the drive shaft housing.
Check the rubber mounts 2 and dampers 3 for
2.
abnormalities such as cracks and fissures. Replace if any
abnormality is found.
3. Remove the idle exhaust port cover bolt, then remove the
idle exhaust port cover 4, gasket 5, and plate 6.
Loosen the idle exhaust port cover bolts in the
order shown in the diagram.
4. Check the idle exhaust port cover and interior for sludge,
cracks, fissures, or other abnormalities.
4st 25/30 2022
7
7-31