SATO CL4NX Operator's Manual page 374

7 Appendix
Connector Pin Specifications
10
11
12
13
14
*
*
Note
• You can set the external signal (EXT) type (TYPE1 to TYPE4) for Print Done output signal of pin No. 6.
Refer to the EXT Mode
• You can set the pin number for input and output through the Settings > Interface > External I/O > Signals
> Inputs and Outputs
• The Print Done signal of pin No. 6 is not outputted when 0 is specified in the number of cuts in the command
specifying the number of cuts during the cutter operation.
372
CL4NX/CL6NX Operator Manual
Output Ribbon Near End:
Outputs a high signal when the ribbon
near end is detected.
- -
- +24 V ± 10%
- Vcc +5 V
- -
Output Dispense completion waiting signal:
Outputs a low signal when the dispense
is completed.
You can set the pin number for output
through the Settings > Interface >
External I/O > Signals >
menu.
Output Label Near End signal:
Outputs a high signal when the label
near end is detected.
You can set the pin number for output
through the Settings > Interface >
External I/O > Signals >
menu.
*This feature is supported on printers
from serial number 6B~ and above.
screen of the Interface > External I/O > Signals menu for details.
menu.
Withstand voltage 50 V
Sink current 50 mA
-
2 A
500 mA
-
Withstand voltage 50 V
Sink current 50 mA
Outputs
Withstand voltage 50 V
Sink current 50 mA
Outputs