SATO CL4NX Operator's Manual page 175

MCS Prefix Digit
Interface > RFID > MCS > MCS Prefix Digit
Set the length of manually assigned MCS manufacturer prefix.
This screen shows only if you have selected Manual in the Assign Prefix
menu.
The options are as follows:
• None: Set the number of digits of the prefix data to 0.
Fill in 0 for all three 3 digits of the prefix data.
• 1 bit: Set the number of digits of the prefix data to 1 digit.
Fill in 0 for the lower 2 bits of the prefix data.
• 2 bits: Set the number of digits of the prefix data to 2 digits.
Fill in 0 for the lower 1 bit of the prefix data.
• 3 bits: Set the number of digits of the prefix data to 3 digits.
Note
Does not show if Chip Manufacturer is NXP and Pre-Encoded Tag is
enabled.
Input Prefix
Interface > RFID > MCS > Input Prefix
Set the contents of MCS prefix.
This screen shows only if you have selected Manual in the Assign Prefix
menu and if you have selected anything other than None in the MCS
Prefix Digit menu.
The setting range is from 0 to 7.
Note
• Does not show if Chip Manufacturer is NXP and Pre-Encoded Tag is
enabled.
• The setting range varies depending on the setting value in MCS Prefix
Digit.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
U
HF
U
HF
173