Paper Sensor - SATO CL4NX Operator's Manual

Paper Sensor

Tools > Test Print > Paper Sensor
Print the detection result of the media sensor level.
1. Check and set the items as listed on the Paper Sensor menu.
2. Press the right soft button to start the test print. Press the right soft
button again to pause the print.
To stop the test print, first pause the print and then press the
The setting items are as follows:
1 Label Width
2 Label Length
3 Pitch
Shows the necessary media width of the test
print.
The necessary media width is 101.6 mm (4")
for Large and 50.8 mm (2") for Small.
Set the length of one piece of the media used
for the test print.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: 400 to 1600 dots
• 305 dpi: 600 to 2400 dots
• 609 dpi: 1200 to 4800 dots
<CL6NX>
• 203 dpi: 400 to 1600 dots
• 305 dpi: 600 to 2400 dots
Set the print position in the vertical direction.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
• 609 dpi: -90 to 0 to 90 dots
<CL6NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
When you decrease the setting value, the print
position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the print
position moves opposite the feed direction
(toward the end part of the media).
4 Operation and Configuration
button.
Note
The value of Label Length,
Pitch, Offset and Darkness
Adjust set in the Paper
Sensor menu will reflect to
the same item settings in the
Factory menu, Configure
List menu and Configure
QR menu.
CL4NX/CL6NX Operator Manual
221