SATO CL4NX Operator's Manual page 95

Advanced
Printing > Advanced
Set detailed sensor operation and print motion.
The setting items are as follows:
1 Calibrate
2 Head Check
3 Head Check Mode
4 Every Page
5 Check Media Size
6 Adjustments
7 Start Online
8 Feed After Error
9 Feed At Power On
10
Finisher Feed
11
Paper End
12 Head Base Position
13 Prioritize
14
Reprint
15 Print End Position
16 Label Near End
Adjust the media sensor.
Check if there is a broken element of the print
head.
Set the mode for head check.
*Shows only if you have selected All or
Barcode in the Head Check menu.
Set the interval for head check.
*Shows only if you have selected Every Page
in the Head Check Mode menu.
Enable or disable media size check.
*Shows only if you have selected Gap or
I-Mark in the Sensor Type menu.
Correct the offset, print position and print
darkness.
Set whether to power on the printer in online
mode.
Set whether to automatically feed the media
when recovering from an error.
Set whether to automatically feed the media at
power on.
Set the length to feed after printing.
Select the sensor for sensing the paper end.
Set the edge position for printing.
Select the prioritized setting.
Enable or disable the reprint function.
Adjust the media stop position or cut position
when Sensor Type is set to None.
Enable or disable the warning when the media
is about to run out.
*This feature is supported on printers from
serial number 6B~ and above. Although this
setting shows on printers with serial number
6A~ or below, it is not supported.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
93