Auto Measure; Ribbon Near End - SATO CL4NX Operator's Manual

4 Operation and Configuration

Auto Measure

Printing > Auto Measure
The printer automatically measures the length of the media.
The measured length of the media will be automatically saved in Label
Length.
The Auto Measure function can be performed when Sensor Type is set to
Gap or I-Mark.
The setting procedure of the label length using the Auto Measure function
is as follows:
1. Load the media.
2. Set Auto Measure to Enabled.
3. Press the
4. Open the print head. (Head Open error occurs)
5. Close the print head. (Returns to offline screen)
6. When you press the
and measures the label length.
7. The measured label length will be saved in Label Length.
Note
When you have set Auto Measure to Enabled, this function executes
when the printer powers on.
Ribbon
Printing > Ribbon
Set whether to print using a ribbon or direct thermal media.
The options are as follows:
• Use Ribbon: Print with a ribbon.
• Direct Thermal: Print using direct thermal media.

Ribbon Near End

Printing > Ribbon Near End
Show or do not show the warning icon when the ribbon is about to run out.
Shows only if you have selected Use Ribbon in the Ribbon menu.
The options are as follows:
• Enabled: Show the warning icon.
• Disabled: Do not show the warning icon.
Note
The warning icon shows in the status bar on the upper part of the screen.
86
CL4NX/CL6NX Operator Manual
button or button to show the online or offline screen.
button, the printer feeds two pieces of label