Adjusting The Media Stop Position - SATO CL4NX Operator's Manual

5.3.3

Adjusting the Media Stop Position

Set the Offset in the Printing > Advanced > Adjustments menu to adjust the media stop position.
Media feed direction
Adjustment for
"+" value
No
adjustment
Adjustment for
"-" value
Note
• The above cut reference position for printing indicates the label stop position when the media sensor is set
to Gap sensor.
• You can also adjust when the operation mode is specified to Tear-off or Dispenser.
Adjust the stop position using the
1
When the printer is in online mode, press
the button on the operator panel to
change to offline mode.
2
Press the button to show the Settings
menu.
Print position
Cut position (Print head)
-3.75 mm (-0.15") ~ +3.75 mm (+0.15")
procedure:
following
5 Cleaning and Performing Printer Adjustments
Setting range:
<CL4NX>
203 dpi: -30 to +30 dots
305 dpi: -45 to +45 dots
609 dpi: -90 to +90 dots
<CL6NX>
203 dpi: -30 to +30 dots
305 dpi: -45 to +45 dots
CL4NX/CL6NX Operator Manual
265