SATO CL4NX Operator's Manual page 221

Configure List
4 Offset
5 Darkness Adjust
Configure QR
Tools > Test Print > Configure QR
Print the configuration information with a QR code.
1. Check and set the items as listed on the Configure QR menu.
2. Press the right soft button to start the test print. Press the right soft
button again to pause the print.
To stop the test print, first pause the print and then press the
The setting items are as follows:
1 Label Width
Set the stop position of the media.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
• 609 dpi: -90 to 0 to 90 dots
<CL6NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
When you decrease the setting value, the stop
position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the stop
position moves opposite the feed direction
(toward the end part of the media).
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
Shows the necessary media width of the test
print.
The necessary media width is 50.8 mm (2") for
Small.
4 Operation and Configuration
button.
CL4NX/CL6NX Operator Manual
219