SATO CL4NX Operator's Manual page 125

Wi-Fi Direct
Interface > Network > Settings > Wi-Fi > Wi-Fi Direct
Set the Wi-Fi Direct function.
*The Wi-Fi Direct function is enabled only if you have selected
Infrastructure in the Mode menu. If you have changed the setting from
Ad-hoc to Infrastructure in the Mode menu, reboot the printer before
setting the Wi-Fi Direct function.
The setting procedure is as follows:
1. Set the device name for the printer using Device Name. You can enter
1 to 32 characters including alphabets (capital and small letters),
numbers and symbols. Press the
and press the right soft button to enable changes.
2. Select Connect to search and show the connectable device names or
to accept connection requests when printer is GO (Group Owner).
Select the device name you want to connect using the
then press the right soft button.
3. Select Start Group if you want to start a new persistent group or select
a group from the list.
4. Select Remove Group to remove the persistent group in step 3.
5. Complete the connection according to the display on the printer or
device you want to connect.
6. Select Disconnect if you want to stop the connection.
Note
You can connect a maximum of ten devices.
When Wi-Fi Direct is active, Device Name cannot be changed.
Start Group and Remove Group show only if Wi-Fi is active and the
printer is not connected to a Wi-Fi Direct network.
Disconnect shows if Wi-Fi is active and the printer is connected.
After setting up a start group, the printer will be set to GO (Group Owner)
and will wait for a connection request from another device.
If the printer is powered off during a persistent group connection, the group
will be started automatically after the printer is powered on.
button to return to Wi-Fi menu
/
buttons,
4 Operation and Configuration
Connect without group
Connect with group
CL4NX/CL6NX Operator Manual
123