SATO CL4NX Operator's Manual page 165

EXT Mode
Interface > External I/O > Signals > EXT Mode
Set the mode of the Print End Signal.
The options are as follows:
Type Operation Details
TYPE1 The print end signal (PREND) is High before label
printing, and it becomes Low after print completion. The
signal level becomes High after 20 ms.
TYPE2 The print end signal (PREND) is Low before label
printing, and it becomes High after print completion. The
signal level becomes Low after 20 ms.
TYPE3 The print end signal (PREND) is High before label
printing, becomes Low from the start to the end of print,
and becomes High again after print completion.
TYPE4 The print end signal (PREND) is Low before label
printing, becomes High from the start to the end of print,
and becomes Low again after print completion.
*Refer to Section 7.8.7 External Signal Interface (EXT)
Chart of the EXT Output Signal.
4 Operation and Configuration
for the Timing
CL4NX/CL6NX Operator Manual
163