SATO CL4NX Operator's Manual page 117

IPv4
Interface > Network > Settings> Wi-Fi > IPv4
Configure IPv4 for Wi-Fi. The setting items are as follows:
1 Mode
2 DHCP / Renew
Lease
3 IP Address
4 Netmask
5 Gateway
6 DNS
CAUTION
After doing the settings, return to the Wi-Fi screen by pressing the
back button, and then press the right soft button to enable the new
settings. Press the left soft button to cancel the new settings and return to
the previous settings.
Note
When Wi-Fi Direct is active, Mode, DHCP and DNS are not shown. In
addition, you cannot change IP Address, Netmask or Gateway if Mode is
DHCP or Wi-Fi Direct is active. DNS cannot be changed if Mode is DHCP.
Select the IP address assignment method.
Update the lease time and get the IP address
from the DHCP server again.
*Shows only if you have selected DHCP in the
Mode menu.
*Does not show if LAN is the active interface.
Set and check the IP address.
If you have selected DHCP in the Mode menu,
the screen shows the IP address you received
from the DHCP server.
If you have selected Static in the Mode menu,
select to set the IP address.
Set and check the subnet mask address.
If you have selected DHCP in the Mode menu,
the screen shows the subnet mask address
you received from the DHCP server.
If you have selected Static in the Mode menu,
select to set the subnet mask address.
Set and check the default gateway address.
If you have selected DHCP in the Mode menu,
the screen shows the gateway address you
received from the DHCP server.
If you have selected Static in the Mode menu,
select to set the default gateway address.
Set and check DNS server addresses.
If you have selected Static in the Mode menu,
select to set and check DNS server addresses.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
115