SATO CL4NX Operator's Manual page 169

RFID (CL4NX only)
Interface > RFID
Perform the RFID settings.
*Shows only for the RFID model.
The setting items are as follows:
1 Antenna Pitch
2 Write Power
3 Read Power
4 Tag Offset
5 Reader Model
6 Reader Version
7 View
8 Retry Mode
9 Retries
10 Mark bad tags
11 MCS
12 Non-RFID
Warning
13 Log RFID Data
14 Data To Record
15 Output Error
Mode
16 Pulse Length
17 Counters
Set the antenna pitch.
Set radio power level used to write information
to RFID tag.
Set radio power level used to read information
from RFID tag.
Set distance to print on label BEFORE pausing
to encode RFID.
Shows the RFID module model.
Shows the RFID module firmware version.
Shows the RFID tag data.
Set whether to retry encoding of failed data
when an RFID error occurs.
Set the number of failed encoding attempts
before error warning/print pause.
Set the error print for the RFID tag error.
Set the Multi vendor Chip-based Serialization.
Set the non-RFID warning message.
Set the log function to record the encoded tag
information.
Set the data to be recorded.
Set the signal type for RFID errors.
Set the length of an RFID error pulse.
*Shows only if you have selected Pulse in the
Output Error Mode menu.
Shows the RFID counter.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
167