SATO CL4NX Operator's Manual page 159

Flow Control
Interface > USB > Flow Control
Set the communication protocol.
The options are as follows:
• Status4
• Status5
• None
BCC
Interface > USB > BCC
Enable or disable the BCC check function.
Shows only if you have selected Status5 in the Flow Control menu.
The options are as follows:
• Enabled: Enable the BCC check function.
• Disabled: Disable the BCC check function.
Bluetooth
Interface > Bluetooth
Set the Bluetooth connection.
The setting items are as follows:
1 Enable
2 Name
3 PIN Code
4 BD Address
5 Firm Version
6 Host BD Addr
7 Authentication
8 ISI
9 ISW
10 PSI
11 PSW
12 CRC Mode
13 Flow Control
Enable or disable the functions for Bluetooth.
Set the device name for the printer.
Set the PIN code.
Shows the BD address of this printer.
(You cannot change this address.)
Shows the firmware version of the Bluetooth.
(You cannot change this value.)
Check the Host BD address.
Set the authentication level.
Set the ISI communication parameter.
Set the ISW communication parameter.
Set the PSI communication parameter.
Set the PSW communication parameter.
Set the CRC check function.
Set the communication protocol.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
157