SATO CL4NX Operator's Manual page 352

7 Appendix
• Barcodes printed within the following range from the print end position cannot be read and a reading
error inevitably occurs. As the following table is only for a reference, be sure to do a test read carefully
in advance.
Print modes
Continuous
Cutter
Cut & Print
Dispenser
Linerless (CL4NX only)
• The barcode check is not performed if the position at which the check starts is detected after the label
feeding begins to stop. Define the label layout and position at which the check starts by keeping in
mind that the distance required for stopping is proportional to the print speed.
• Printed barcodes or 2D codes can be read only with a size at which their entire pattern is within the
scanning range of the barcode checker. A reading error may occur depending on the print position.
• This function cannot be controlled through the use of external signals (EXT).
Restrictions When Using GFS4470
• By the double-reading prevention function, the barcode checker may not read barcodes that are
printed successively if they are within the readable area. Adjust the print position so that same
barcodes are not within the readable area.
• When printing composite symbols that use GS1 DataBar, the read data and print data never match if
the barcode data is 16 digits or less. A comparison error occurs in comparison mode.
• Though "\" (0x5C) specified in MAXI code, print data should be read as "\\" in the specifications.
However, it may not be read as such, depending on the following data. For example, "\A" specified in
print data should be read as "\\A" in the specifications, but it is actually read as only "A".
Restrictions When Using WB1F-100S1S
• Multiple barcodes cannot be read at the same time.
• When NUL (0x00) is included in CODE128 print data, only the data before NUL is recognized as
reading data, and NUL and the data after NUL are ignored. A comparison error occurs in comparison
mode. In readable mode, a reading error occurs only if NUL is specified at the beginning of the print
data.
350
CL4NX/CL6NX Operator Manual
Ranges to be avoided
Approximately 11 mm (0.43") from the print end position
• Cutting every label
Approximately 25 mm (0.98") from the print end position
• Cutting according to the specified number of labels
Approximately 44 mm (1.73") from the print end position
Approximately 44 mm (1.73") from the print end position
No restriction
Approximately 25 mm (0.98") from the print end position