SATO CL4NX Operator's Manual page 220

4 Operation and Configuration
Configure List
Tools > Test Print > Configure List
Print the configuration information of the printer.
1. Check and set the items as listed on the Configure List menu.
2. Press the right soft button to start the test print. Press the right soft
button again to pause the print.
To stop the test print, first pause the print and then press the
The setting items are as follows:
1 Label Width
2 Label Length
3 Pitch
218
CL4NX/CL6NX Operator Manual
Shows the necessary media width of the test
print.
The necessary media width is 50.8 mm (2") for
Small.
Set the length of one piece of the media used
for the test print.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: 400 to 1600 dots
• 305 dpi: 600 to 2400 dots
• 609 dpi: 1200 to 4800 dots
<CL6NX>
• 203 dpi: 400 to 1600 dots
• 305 dpi: 600 to 2400 dots
Set the print position in the vertical direction.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
• 609 dpi: -90 to 0 to 90 dots
<CL6NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
When you decrease the setting value, the print
position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the print
position moves opposite the feed direction
(toward the end part of the media).
button.
Note
The value of Label Length,
Pitch, Offset and Darkness
Adjust set in the Configure
List menu will reflect to the
same item settings in the
Factory menu, Configure
QR menu and Paper Sensor
menu.