Bpdu Tunnel Configuration; Bpdu Tunnel Overview; Introduction To The Bpdu Tunnel Feature; Bpdu Tunnel Fundamental - H3C S3100 Series Operation Manual

3

BPDU Tunnel Configuration

This chapter is only applicable to S3100-EI series switches.
When configuring BPDU tunnel, go to these sections for information you are interested in:

BPDU Tunnel Overview

BPDU Tunnel Configuration
Displaying and Maintaining BPDU Tunnel Configuration
BPDU Tunnel Configuration Example
BPDU Tunnel Overview

Introduction to the BPDU Tunnel Feature

Normally, Layer 2 protocols are needed in a LAN for network topology maintenance and management.
For example, spanning tree protocol (STP) is used for maintaining spanning trees and preventing loops.
Huawei group management protocol (HGMP) is used for managing network topology and devices in a
network.
When multiple branch networks of an organization are connected together through a public network,
you can combine the corresponding network nodes into one so as to maintain the branch networks as a
whole. This requires the packets of some of the user's Layer 2 protocol packets be transmitted across
the provider's network without getting involved in the computation of the public network.
The BPDU Tunnel feature is designed to address the above requirements. It enables some Layer 2
protocol packets of private networks to be transmitted along tunnels established in the public network.

BPDU Tunnel Fundamental

Layer 2 protocol packet identification
Different from the processing of data packets, a Layer 2 protocol packet is classified first when it
reaches a network device. A Layer 2 protocol packet conforming to IEEE standards carries a special
destination MAC address (for example, the destination MAC address of an STP protocol packet is
0180-c200-0000) and contains a type field. Some proprietary protocols adopt the same packet structure,
where a private MAC address is used to identify the corresponding proprietary protocol, and the type
field is used to identify the specific protocol type.
Transmitting BPDU packets transparently
As shown in Figure
bottom is a customer network. The service provider network contains edge devices connecting the
3-1, the network on the top is the service provider network, and the one on the
3-1