Starting A Call To Downloader - Eaton Menvier 20 Administrator's And User Manual

4. Administration
Press  until the display shows:
8.
Press .
9.
The display shows:
10. Press . or  until the display
shows:
11. Press 
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
12. Press  repeatedly to leave the
menu.
Once you have carried out this process, then a user with a Fob-2W-4B can
start a HUA by pressing any two diagonally opposite buttons on their fob at
the same time. Users with a 727r remote control must press the top and
bottom buttons (A and ) at the same time.

Starting a Call To Downloader

Note: This option is available only if you have the appropriate
communicator module fitted inside the control unit and it has been
programmed by the installer. You can use the About menu to check
if you have a communication module fitted, see page 108.
Your installer may be using a personal computer connected to the
telephone network (PSTN) in order to program your alarm system. The
software the Installer uses to program your alarm system is called
Downloader.
There may be times when your Installer asks you to make your alarm
system start a telephone call out to the installer's Downloader. Your alarm
system is programmed to call up to two different telephone numbers. You
do not have to know these numbers, your Installer will tell you to select one
of them.
To start the call:
Page 104
Menvier30/40/100/300








