Adjusting Staple Position (1-Stapling At The Rear) - Canon Finisher-AK1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (1-stapling at the rear) > Procedure

Adjusting Staple Position (1-stapling at the rear)

Execute this adjustment in the case of displacement of stapling position (1-stapling at the
rear) or replacing the finisher controller PCB.
Adjusting method is as follows:
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
In the case of A-configuration size:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (1-stapling at the rear) > Procedure
ENTER
F-5-65
In the case of L-configuration size:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press switch SW385 [1] to start adjustment of the 1 stapling position at the rear.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-66
ENTER
[1]
F-5-67
5-29
5-29