Adjusting The Paper Alignment - Canon Inner Finisher-L1 Service Manual

Adjusting the Paper Alignment

■ Adjusting the Alignment Position at Staple Mode
< Use case >
• When the paper alignment position is displaced in feed direction at the staple mode or staple-free staple mode.
• When the paper alignment position is displaced in front/rear direction at the staple mode or staple-free staple mode.
< Procedure of adjustment >
NOTE:
After the setting value is changed, write the changed value in the service label.
1. Adjust the width of the Alignment Plate by the following service mode.
• SORTER > ADJUST > INF-ALG3
Adjustment range: -50 to 50 (Unit: 0.1 mm)
As the value is incremented by 1, the width of the Alignment Plates becomes narrow by 0.1 mm.
+: When the paper alignment position is displaced in front/rear direction, increase values
-: When the paper alignment position is displaced in feed direction, decrease values
Feed Direction
Feed Direction
101
Feed Direction
Feed Direction
5. Adjustment