Adjusting Position For Saddle Alignment Width - Canon Finisher-AK1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjusting Position for Saddle Alignment Width > Procedure

Adjusting Position for Saddle Alignment Width

Execute this adjustment in the case of displacement in position for saddle alignment width.
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
• In the case of A-configuration [2]
• In the case of L-configuration [3]
Then, press SW385 so that the adjustment is ready now.
[2]
[3]
5 Adjustment > Auxiliary Adjustment > Adjusting Position for Saddle Alignment Width > Procedure
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-221
2) Hold the lever [1] to pull out the saddle unit [2], and then open the saddle right guide [3].
[2]
[1]
3) Set paper [2] on the saddle assembly [1] (A4R or LTRR).
4) Check that there is gap between the saddle guide plate and the paper edge.
If there is a gap, go through the following steps.
[3]
F-5-222
[2]
[1]
F-5-223
5-94
5-94