REP 8.1.3.9 Duplex Exit Gate Solenoid
Parts List on PL 8.1.2.3
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Duplex Cover (REP 8.1.3.2).
3 Remove the Duplex Rear Cover (REP 8.1.3.3).
4 Disconnect P/J 222 from the Duplex PWB (Figure 8.1.3.9a).
5 Remove the wire harnesses from the two wire clips that are mounted on the Solenoid Bracket
(Figure 8.1.3.9a).
6 Remove the two screws securing the Duplex Exit Gate Solenoid Bracket to the Duplex frame,
and remove the Bracket and attached Solenoid (Figure 8.1.3.9a).
7 Remove the two screws securing the Duplex Exit Gate Solenoid from the Bracket, and remove
the Solenoid (Figure 8.1.3.9a).
DocuPrint N24, N32 and N40 Service Manual
Figure 8.1.3.9a. Duplex Exit Gate Solenoid
3/99
8-35
Options