Xerox DocuPrint N24 Service Manual page 193

10 Open the cable clamp and disconnect the Registration Clutch in line connector (P/J 200) (Figure
4.9.1b).
11 Remove the three screws that secure the Harness Support to the Main Drive Assembly (Figure
4.9.1b).
12 Remove the Harness Support and allow the support to hang down (Figure 4.9.1b).
13 Disconnect the harness from CN1 on the Main Motor PWB (Figure 4.9.1b).
14 Release the wire harness (located just above the Main Motor PWB) from the wire clip and move
the harness out of the way (Figure 4.9.1b).
15 Remove the screw securing the green ground wire to the Main Drive Assembly, and move the
wire out of the way (Figure 4.9.1b).
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.9.1b. Main Drive Assembly.
2/2000
4-79 Repair Procedures