Rep 8.5.3.57 Eject Clamp Sensor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.57 Eject Clamp Sensor

Parts List on PL 8.5.2.19
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Upper Rear Cover (REP 8.5.3.5).
3 Remove the wire harnesses from the wire clamps that are attached to the Eject Bracket (Figure
8.5.3.57a).
4 Remove the screw securing the Eject Clamp Sensor Bracket to the Eject Bracket, and remove
the Sensor Bracket, along with Sensor (Figure 8.5.3.57a).
5 Disconnect P841 from the Sensor (Figure 8.5.3.57a).
6 Press in and release the Sensor latches that secure the Sensor to the Bracket, and remove the
Sensor (Figure 8.5.3.57a).
Options
Figure 8.5.3.57a. Eject Clamp Sensor.
3/99
8-402 DocuPrint N24, N32 and N40 Service Manual